Lukas LSI 55 Manual do Utilizador

1CutterLSI 501, LSI 511, LSI 530, LSI 5584150/1490-85 GBIssue 07.2006Operating InstructionsRecycling systemLSI501LSI511LSI530LSI551 4/3-way-valve with

10Before connecting, withdraw and hold the locking socket (position X). Connect the nippleand socket and release the locking socket. Then turn the l

11Then fix the LSI cutter to the swivel hanger (seepicture left).Note: The device cannot be clamped tighter inthe hanger! This is because the cutter

128.2 Operating the 4/3-way valve with the star gripOpen device (extend):Turn the star grip clockwise and hold in this position until the blades reach

13right false9 Cutting9.1 Safety instructions- Woldwide all national safety guidelines must be observed and complied.- If there is a explosion risk, d

1410 Dismantling the device / switching off after use10.1 CutterAfter end of working, the blades should be closed till a few mm of tip distance. This

1512 Repairs12.1 GeneralServicing should only be carried out by the manufacturer of by staff trained by themanufacturer and by authorised LUKAS dealer

16Attention!When working with upturned blades, in particular, please ensure that no coarsefragments reaches the mechanical parts under the hand guard

17boltcentral bolt blade armretaining ringsliding plateself-locking nut12.2.3 Function and load testIf there are doubts about the safety and reliabili

18Note: Defective parts (blades, bolts, sliding plates) should always be replaced aspairs. If you detect, when changing blades, that the levers are d

1913 TroubleshootingIf the defects cannot be repaired, contact an authorised LUKAS dealer or theLUKAS service department.The address of the LUKAS serv

2Content Page1 Correct use of the device 32 Organisational measures 33 General safety instructions 44 Maintenance and servicing instructions 55 Safety

2014 Technical data * 1MPa = 10 bar;** Necessary oil quantity in the hydraulic power pack for operating the tool(Difference in quantity piston / rod s

21 * 1MPa = 10 bar;** Necessary oil quantity in the hydraulic power pack for operating the tool(Difference in quantity piston / rod side)14.1 Central

2214.5 Cutting performanceCutting materialmax.continuous operationmax.continuous operationmax.continuous operationmax.continuous operation[mm] [mm] [m

2314.6 Test pressuresThe stated reference test pressures only refers to the measurement with the LUKAStesting kit (from the LUKAS accessories programm

31 Correct use of the device1.1. The device has been constructed according to the latest technology and therecognised safety regulations. However, da

42.6 The operating pressure marked on the device must not be exceeded.2.7 Only original LUKAS parts and original LUKAS accessories and systemcomponent

53.12 The generation of an electrostatic charge producing sparks as a possibleconsequence should be avoided when working with the device.3.13 When wor

65 Safety instructions for hose lines- The hoses must never come into contact with brake fluid.- After coming to contact with the following fluids, th

75.1 Handling instructions for hose lines- The defined operating pressure must not be exceeded.- The hoses must not be subjected to tension and torsio

8cuttingopen5.5 Periods for checking and replacing hose lines- Check the hose lines for external damage, tears, bends and inflating afterevery use.- T

96.2.3 LSI cutter with cylinder bottomThe cutter with cylinder bottom is controlled with pressure to the correspondinglylabelled connection nipple (se