Lukas traversing system Manual do Utilizador descarregar pdf (Página 10)

Only the speciﬁ ed LUKAS hydraulic power packs (motor pumps) or suitable LUKAS hand

pumps can be used to drive the equipment.

If the pump unit is a different make, you must make sure that it complies with LUKAS

speciﬁ cations, otherwise potential dangers may occur which are not the responsibility of

LUKAS. Ensure in particular that the maximum permissible operating pressure for the

connected LUKAS equipment is not exceeded.

NOTE:

Before you use pumps from a different manufacturer, you must contact LUKAS

or an authorised dealer.

The connection between the hydraulic power pack (pump unit) or hand pump and the

hydraulic cylinders is by hoses.

4.2 Hydraulic supply to the cylinders

5.1 Basic aspects

On the double-acting hydraulically-actuated working equipment, there is, on the

pressure supply side (with cylinders: on the cylinder base side) a plug coupling nipple

and on the return side (with cylinders: on the piston rod side) a plug connection sleeve; and

these are connected to the control unit by pairs of hose extensions.

A plug connection nipple is provided on the single-acting hydraulically-actuated

working equipment; and this is connected to the pump unit or control unit via hose

extension.

If you are using single-acting cylinders (particularly of a previous type), LUKAS recommends

that you contact LUKAS or an authorised dealer. Using single-acting locking-cylinders a

sticker (accessory order no. 43010073) is available to simplify operation. For unlocking the

control leaver must be pulled in direction of the the operator.

The hose extension pairs are supplied in various lengths. The individual hoses can, if

required, also be marked with coloured snap rings to make it easier to allocate the hoses.

(For speciﬁ c details, please consult the LUKAS range of accessories or contact your LUKAS

dealer.)

5. Connecting the hydraulic equipment

WARNING / CAUTION / ATTENTION!

Prior to connecting the devices, ensure that all the components

being used are suitable for the maximum operating pressure

of the pump unit! In case of doubt you must consult LUKAS

directly!

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Sem comentários

Lukas traversing system Manual do Utilizador Página 10